Fill areas with hatches

Updated November 13, 2026

A hatch fills an area with a pattern or a solid color.

Hatch an area

  1. Type H and press Enter.
  2. To change the pattern, type P, then S solid, D diagonal, C cross, G grid or B brick. SC sets its scale and A its angle.
  3. Click inside the area. It finds the boundary around the click, and things inside it (a table, a column) stay clear. Click more areas, then press Enter.
  4. To pick closed shapes instead of clicking inside, type O and select them.

Change it

  • Select the hatch to change its pattern, scale and angle in Properties.
  • A hatch made by clicking inside follows its boundary: stretch a wall and the hatch fits the room again. Undo takes back both.

Tips

  • Hatches go on A-HATCH and draw under the lines around them.
  • To blank out an area instead of filling it, use a wipeout.

Need more? Every command, or contact us.

Was this article helpful?