Construction lines, Divide and Measure

Updated November 13, 2026

Construction lines help you lay out a drawing. Divide and Measure put marks along an object at equal spacing.

Construction lines and rays

  1. Type XL and press Enter.
  2. Click a point, then each point the line runs through. Or type H, V or A first for horizontal, vertical or angled lines, then click where each one goes.
  3. RAY works the same way but runs one way only.

They go on the grey A-CONS layer, run well past the drawing, and are left out of Zoom extents. Freeze or turn off A-CONS to hide them.

Divide and Measure

  1. Type DIV (divide) or ME (measure) and click a line, arc, circle, polyline, spline or ellipse.
  2. Divide: type how many equal parts, like 5. Measure: type the spacing, like 4’. Measure starts from the end you clicked near.
  3. Small + marks go at each spot. To place one of your blocks instead, type B first, then its name, and choose whether it turns with the object.

Tips

  • Snap to the + marks with object snaps (they’re short crossing lines).

Need more? Your own blocks, or contact us.

Was this article helpful?