Draw lines, polylines and shapes

Updated November 13, 2026

Pick a tool on the left or type its short name. Every shape can be clicked or typed.

Lines and polylines

  1. Type L (line) or PL (polyline) and press Enter.
  2. Click a start point, then click or type each next point, such as 12’ with the cursor pointing the way you want.
  3. Type C to close back to the start, U to undo the last segment, or press Enter to finish.

In a polyline, A switches to arcs (each one flowing on from the last) and L back to lines.

Shapes

  • REC: a rectangle from two corners, or one corner and @20’,14’.
  • C: a circle from its center and radius.
  • A: an arc from its center, start and end.
  • POL: a regular polygon. Type the number of sides, then its center and radius.
  • EL: an ellipse from its center and the ends of its two axes.
  • SPL: a smooth curve through the points you click.

Tips

  • The tool asks for one thing at a time in the command line: read it when you’re not sure.
  • Polar tracking (F10) shows a dashed guide every 15 degrees. F8 (ortho) keeps lines straight across or up and down.

Need more? Exact lengths and points, or contact us.

Was this article helpful?