Constraints
Updated November 17, 2026
A constraint keeps a rule as you edit: this line stays horizontal, these two stay parallel, this wall stays 12’ long.
Add one
- Type CONSTRAINTS (or GC), or choose Constraints in the dimension tools. A bar of constraints opens.
- Choose one, then pick the objects.
| Button | What it keeps | Command |
|---|---|---|
| Horizontal, Vertical | A line level or plumb | GCH, GCV |
| Parallel, Perpendicular | Two lines at that angle | GCPA, GCPE |
| Equal | Two lengths or radii the same | GCE |
| Coincident | Two points together | GCC |
| Fixed | A point where it is | GCF |
| Dimension | A length you set | DCLINEAR (DCL), DCALIGNED |
Constrain what’s drawn (GCINFER) adds constraints for what’s already there in one go.
See and take them off
- Constraints show as small tags on the drawing. One that can’t hold is red.
- The bar says how far along you are: No constraints yet, how many ways the drawing can still move, or fully constrained.
- Take off (DELCONSTRAINT) removes every constraint on the objects you pick. The objects stay where they are.
Good to know
- A constraint that conflicts with what’s already held isn’t added, and it says so.
- Constraints are kept in .ccad files. DWG and DXF get the shapes, not the constraints.
Need more? Dimensions, or contact us.