References (xrefs)

Updated November 17, 2026

A reference shows another drawing under yours, faded, like the architect’s plan under your electrical layout. It isn’t changed in your drawing, and it can follow the original.

Attach a reference

  1. Choose File › Attach a reference…, type XATTACH (or XREF), or choose Attach… under References in the Layers tab.
  2. Choose MyCloudSuites or This computer, then Choose a drawing…: a .ccad, .dxf or .dwg file.
  3. Set where it goes (At), its Scale and Turn, and choose Attach.

A copy is kept with your drawing, so it still shows offline.

Work with a reference

Each reference has a card under References, at the top of the Layers tab:

  • Reload reads the original again. One from MyCloudSuites says when the original has changed since it was loaded.
  • Clip shows only part of it: pick two corners of a rectangle. Unclip shows it all again. You can also type XCLIP.
  • Bind makes its objects your drawing’s own, on layers named after the reference. It stops following the original.
  • Detach takes it out of your drawing. The original isn’t touched, and Undo brings it back.
  • Fade sets how faded it shows, and Its layers turns its layers on or off.

Good to know

  • Only references from MyCloudSuites are checked for changes, and only while you’re online. For one from this computer, Reload asks for the file again.
  • A .dwg reference is converted on our server when you attach it.

Need more? Layers, DWG and DXF, or contact us.

Was this article helpful?